After you have fixed the bath or shower drain, you should take a shot at decreasing its odds of happening again (see my recommendations at the base of the page).
The following are my six proposed techniques for how to fix a slow draining bath or shower drain.
Index: Six Ways to Fix a Slow-Draining Bathtub
- Use baking soda and vinegar (the natural alternative to chemicals).
- Use a commercial (chemical) clog remover.
- Use a plunger.
- Remove the drain stopper to inspect and gain access.
- Use a plumbers’ snake.
- Call a plumber.
I will go into every one of the above techniques in detail underneath. As a rule, the rundown begins with the simpler, less-included, and less expensive techniques and advance to more-included and costly strategies. So if all else fails, start with #1, and work your way down through the rundown.
I would say, clearing a clogged bath or shower drain regularly requires a mix of more than one of these strategies.
1. Baking Soda and Vinegar
A more natural solution than using cleaning chemicals, this method will clear moderate blockages.
How to Unclog a Bathtub Drain Using Baking Soda and Vinegar
1. Pour a half cup of baking soda down the drain opening.
2. Pour a cup of white vinegar down the drain opening.
3. The combined ingredients should foam for five minutes.
4. Run the hot water and allow it to run through the drain for a minute or so.
5. Examine the bathtub drainage to determine if it still is slow.
Note: The two fundamental preferences of this technique are that it is naturally ideal, and won’t cause harm to plastic lines. It isn’t that powerful on genuine blockages, nonetheless, you may in any case wind up turning to synthetic compounds.
2. Commercial (Chemical) Clog Remover
Widely available at hardware stores and supermarkets, strong chemical cleaners are designed to unblock drains. Follow the instructions on the label or box carefully.
How to Unclog a Shower Drain Using Chemicals
- Read and follow the directions on the packaging, including the correct amount of the product to use. This amount you use will vary.
- Use gloves and goggles to protect your hands and eyes.
- Don’t mix together different chemicals. This can cause poisonous gas.
- Pour chemicals down the drain opening.
Note: Synthetics should not be utilized gently. They can harm your drains, particularly whenever used more than once. Utilizing synthetic compounds is regularly a quick, clear, and reasonable strategy with a genuinely high achievement rate I would say. You can lessen the requirement for synthetic substances, notwithstanding, by limiting future blockages happening (see the base of page)!
3. Use a Plunger
Plunging can be fruitful, however, it relies upon the idea of the blockage, the area of the stop up, and the structure of your channel. The plunger requires suction to work. So if the stop up is deep and made of mostly hair, for example, this strategy may not be work.
How to Unclog Your Bathtub Drain Using a Plunger
1. Add petroleum jelly to the edge of the suction pad to get a better seal.
2. Add enough water to the bathtub so that the pad of the plunger is submerged.
3. Plunge the bathtub drain opening vigorously.
Note: On the off chance that utilizing one plunger doesn’t work, have a go at utilizing the two plunger technique. Put one plunger over the overflow cover, so the cup seals it off and ideally gives you better pull, and all the while plunge the drain opening utilizing the other plunger. As a technique, plunging is consistently worth an attempt, as the time and costs included are generally small.
4. Remove the Drain Stopper to Inspect and Gain Access
In the event that you’ve attempted the above strategies and none of them have worked, it’s an ideal opportunity to get dirty. You have to unscrew and remove the overflow plate and remove the plug.
The plug works by lifting and dropping a plunger to open and close the drain. It is worked by a little switch. In the event that the plug isn’t working effectively, it tends to be stuck in a semi-shut position, limiting water flow. The situating of the plunger can be effectively balanced with the lock nuts that hold the plunger to the threaded rod.
On the off chance that the plug works alright, at that point the issue is probably going to be a clog, and you should utilize a plumbers snake. You can utilize the overflow for access.
Note: Hair and cleanser can regularly accumulate underneath the waste sifter as well. So I would suggest eliminating that too for assessment and access. A few sifters can be eliminated physically, while others have screws that should be taken out first.
5. Use a Plumbers’ Snake
This is another reasonable technique for fixing a moderate bath or shower drain. The achievement rate is high if the issue your managing is a clog.
How to Unclog Your Bathtub Drain Using a Plumbers’ Snake
1. Feed the snake down until the clog is reached. You can gain access to the drain via the overflow, once you’ve removed the stopper. An alternative route is via the drain opening after you’ve removed the strainer.
2. Turn the handle to bring it back up.
3. Run water to check the drain, and make sure that the clog is completely gone.
4. You may need to repeat the process several times.
Note: Clogs caused by invasive roots will require more than a plumbers’ snake to fix.
6. Call Me
On the off chance that you can’t take apart your drain and don’t feel great with utilizing synthetic substances (or they just don’t work), at that point you should get ahold of an expert plumber. It’s clearly the last resort in the event that you are hoping to save some cash.
All things considered, it is likewise the least trouble.
What Causes a Tub to Drain Slowly?
Regularly the reason for a moderate slow draining bath or shower drain is a clog that is confining the water stream. Clogs are typically made of tied hair, soil, oil, or potentially cleanser. They can be hard to eliminate in light of the fact that hair can fold over pieces of the channel.
Clogs happen all the more habitually in homes where at least one of the bath or shower users has long hair, as short hair is substantially less liable to get trapped in the drain framework.
Causes of Clogs in Bathtub Drains
- Hair – Hair can combine with soap and dirt and clump together to form clogs. It can also attach to drains and pipes, making it difficult to remove.
- Soap – Traditional soap bars are made with grease or fat. The fat combines with minerals in water and leaves a hard residue that clogs pipes. Soap can also combine with hair and dirt.
- Dirt – Dirt can build up and cause problems. The very nature of bathing means that we are constantly sending dirt down the drain.
- Stopper – If the stopper hasn’t been fitted correctly or is out of position, it may become stuck in a semi-closed position, and the plunger may restrict drainage.
- Tree Roots – Older underground pipes can crack or leak, attracting root growth. Once inside your pipes, roots grow larger, blocking water flow and causing pipe damage.
- Mineral Build-Up – Minerals dissolved in water can build up over time and create insoluble masses that will block your drains.
Symptoms of a Slow-Draining Tub
Slow draining implies that the water remains in the tub for any longer than it ought to after you have pulled the plug, just draining gradually. The issue can grow over some stretch of time and may not be distinguished immediately. Numerous individuals ignore the issue until the issue has gotten serious.
Tragically, when the drainage issues have started, they will normally just get worse after some time without a move being made. This is on the grounds that any clogs will in general gather more debris such as hair, soil, and cleanser after some time and become worse. The sooner that you manage the issue, the simpler it tends to be to resolve.
How to Prevent a Bathtub From Slow-Draining
Prevention is quite often superior to the fix, obviously. So once your drainage issues are settled, remember to limit the chance of your bath drain getting clogged once more. The following are two things to try.
Firstly, you ought to unquestionably consider purchasing a decent drain shield, on the off chance that you don’t as of now have one, to prevent hair, youngsters’ toys, in addition to other little things from clogging the drain.
Secondly, a safe cleanser dish can regularly help, as cleanser adds to clogs forming by restricting bunches of hair together into bigger clusters. (It’s a given that free cleanser falling into the tub, or onto the floor can likewise cause genuine mishaps because of individuals slipping.)
Is There a Good Drain Protector That You Can Recommend for a Bathtub?
There are loads of incredible items out there that will carry out the responsibility adequately. Remember that there are various kinds of bath or shower drain plugs and protectors.
Common types of bathtub drain stopper include:
- Trip lever
In the event that you need me to make an overall recommendation for a defender that works with most of bath and shower drains, I would suggest the OXO Good Grips – this gives an extraordinary hindrance to getting little trash without slowing water drainage and it works with both spring up and ordinary drains. It’s better than a large portion of its adversaries as it has a touch of weight to it thus doesn’t tend to float up into the clouds like a portion of the less expensive defenders do. It’s likewise moderate and simple to clean.
The other bath drain defender that I am a specific fanatic of is the Tubshroom. This defender really fits inside the channel, as opposed to sitting on top, and is especially acceptable at getting hair. On the off chance that your tub is where you flip a switch, at that point you can simply leave the Tubshroom in. On the off chance that the drain has a removable plug, at that point you put the Tubshroom in when the tub is draining. A few people grumble that it is abnormal to clean, yet I’ve not experienced a lot of difficulties.